トップイメージ
ProductsDME TUNEInternational DistributorSpecial DistributorJAPANESEBuyCompany InfoLinksmotor sportsContact usCHINESE
SE Sulser
Super Eco Pulser                

Realization to long life span of a battery, consistent with ecology and economy!!
Set a SE Pulser can control production sulfation then restore performance maintenance support and deterioration.


SE Pulser operate by feel engine start and stop and clearing sulfation phase to puls technology of our original. A battery keeps best condition.

In best condition of a battery, impossible to restore starts head-light brightness ,quality of audio sound .

SE Pulser○ To control sulfation in the lead battery and long life battery by dissolution.
○ Effect for control to deterioration of battery
○ Reform effect in deterioration battery
○ Improve effect for charge efficiency
○ Smoothly sell start restore by full charge(especially high effect in diesel)
○ Restore headlight brightness by full charge
○ Good for ecology by long life battery
○ Cost down by long life battery
○ Promote activation by puls effect to the non-liquid battery, impossible to a long life



You can choose Type A, type B, premium by battery terminal size

PremiumA 6mm terminal type ¥8,600 article number SEPA
PremiumB 8mm terminal type ¥8,600 article number SEPB

Details of premium
This is very precise of item private design for imported car and domestic luxury car with big battery capacity.


Cause of battery deterioration
When the lead battery discharge,pbs04 covered pole board surface with the anode and the cathode. A resist of inside battery rise by crystallize at a pole board surface. Therefore, when the discharge control to occur crystallize or melts by lead sulfate in a battery. it impossible to extend battery life.
sulfate


 





How to remove and control about sulfation phase
Formations puls wave form use ringing occur equipment, rapidly change to incoming signal at an electric circuit. And make periodical signal by transmitter. Ringing sends about 2500~4000times to one second. add to lead battery charge voltage. More increase act by ringing increase equipment. Ringing puls increased a pole board was stimulated continuously by increase ringing puls. Effect detachment from pole board to warm crystallized sulfuric lead Use separately charge equipment and alternator, they promote soluble effect sulfuric to electrolysis liquid.

ringing










ringing wave form


SE Pulser is realized long life to EB battery by puls work. SE Pulser use to one 12v battery each When use to a diesel , in spite of series, parallel use one battery to one SE Pulser.


How to install
@ fit up red terminal of SE pulser to plus terminal at battery
A fit up black terminal of SE pulser to minus terminal at battery
B fix SE pulser with both sides of tape at battery or around there in case of a car installed plural battery ,needs SE pulser number of your use battery


Install attention
Please understand to decrease effects that if you install SE pulser and consenser tuning parts to a battery at the same time, condenser absorb puls from SE puser. However, we think that cigar lighter install type almost doesn’t get influence.


Product specification
Work voltage 13,3v
Inside circuit protect work out fuse 3A
Plan production by RoHS criterion Waterproof heat-resistant resin case
Terminal size 2-6(for 6mm screw) type A , premiumA
Terminal size 2-8(for 8mm screw) type B , premiumB


Attention

About fall out sell and short at battery inside, please change these battery to new one for use SE pulser. Cause it doesn’t work in these bad condition of battery.

Caution
You charge the battery by using a charger, you must put it out SE Pulser.
If you keep charging with connecting it,it causes some troubles and the fire by the heat.
Do not charge rapidly, switch on the currents than 10A and a high voltage than 15V with connecting SE Pulser.

←products
↑TOP

Copyright © T.M.WORKS, Ltd. All rights reserved.